Form Length - Genicom GEK-00027C User Manual

Modify Format

Form Length

Form Length
By Lines (6LPI)
Form Length
006
Form Length
006
GEK-00028C
Form Length
This menu option is used to set the form length. The form length may
be set By Lines (6 LPI) or By Lines (8 LPI).
1. While in Modify Format menu, press the ◄ (left) or ► (right) menu
browse keys until Form Length is displayed in the lower right
corner of the LCD.
2. Press the ▼ (down) menu browse key to access the Form Length
options. Form Length will be displayed in upper left corner of
LCD.
3. Press ◄ (left) or ► (right) menu browse key and select By Lines (6
LPI) or By Lines (8 LPI). Press the Select key to select one of these
options. The current setting is displayed in the lower right corner
of the LCD.
4. Press the Select key again to modify the setting. Notice the cursor
(underline) is now shown under the first digit. The four menu
browse keys revert to data entry operation. The horizontal ◄ ►
(left or right) keys position the cursor (underline) to the digit to be
changed; the vertical ▲ ▼ (up or down) keys
increment/decrement the selected digit by one.
5. Press the Clear key after all changes are complete and the
desired value is displayed in the lower right corner of the LCD.
Pressing the Clear key does not erase the values entered, but does
allow the user to exit the User Set menu.
Repeat this section if further changes are necessary.
Note
55
Chapter 5. Using the Set Up Menu