Table of Contents
Advertisement
IBM Format
MMP Override
MMP Override
Disable<
IBM Format
MPL
MPL
000
GEK-00028C
MPP Override
This enables/disables MPP (maximum print position) Override. When
enabled, the printer will override (ignore) any host-SCS command
which attempts to change MPP. The operator-set value is used.
1. While in the IBM Format menu, press the ◄ (left) or ► (right)
menu browse key until MPP Override is displayed in the lower
right corner of the LCD.
2. Press the ▼ (down) menu browse key to access the MPP Override
options.
3. Press the ◄ (left) or ► (right) menu browse key until the desired
option is displayed. Press the Select key to enable or disable an
option. The < symbol will immediately follow an enabled option.
MPL
MPL sets the value for the default maximum page length in lines. In
SCS mode this value may be overridden by the host-SCS command.
When powered on, the printer computes the available page length. If
the MPL is set to zero or a value greater than the computed
maximum, the printer will use the computed maximum as the
default. In DSC/DSE mode, this option sets the absolute MPL and
cannot be overridden by the data stream.
1. While in the IBM Format menu, press the ◄ (left) or ► (right)
menu browse key until MPL is displayed in the lower right corner
of the LCD.
2. Press the Select key to configure the MPL options.
3. Notice the cursor (underline) is now shown under the first digit.
Use the horizontal ◄ ► (left or right) menu browse keys to
position the cursor (underline) under the digit to be changes; use
the vertical ▲ ▼ (up or down) menu browse keys to
increment/decrement the selected numeric digit by one.
4. Press the Clear key after all changes are complete and the
desired value is displayed in the lower right corner of the LCD.
Repeat this section if further changes are necessary.
Note
109
Chapter 5. Using the Set Up Menu
Advertisement
Table of Contents
Troubleshooting
