Alignment; Patterns - Genicom GEK-00027C User Manual

ALIGNMENT

Maintenance
Alignment

Patterns

Alignment
Patterns
Patterns
Signature
Signature
CLEAR to Stop
GEK-00028C
This menu and its sub-menus are used to make printing
adjustments.
Use the following procedures to select this option:
1. While in the Maintenance menu, press the ◄ (left) or ► (right)
menu browse key until Alignment is displayed in the lower right
corner of the LCD.
2. Press the Select or ▼ (down) menu browse key to access the
Alignment options.
The following describes the options available:
Print the patterns used for adjustments. There are six available
patterns. Signature will print a small sample of each of the other five
patterns. The Amplitude Pattern is used to adjust the amplitude. The
Horizontal Timing, Vertical Timing, and Checkerboard Patterns are
verification patterns. The Inter-module Gap Pattern is used to verify
correct print head mounting.
1. While in the Alignment menu, press the ◄ (left) or ► (right) menu
browse key until Patterns is displayed in the lower right corner of
the LCD.
2. Press the Select or ▼ (down) menu browse key to access the
Patterns options.
3. Press the ◄ (left) or ► (right) menu browse key until the desired
pattern option is displayed.
4. Press the Select key to select a pattern to print. CLR to Stop will
be displayed in the lower right corner of the LCD.
5. Press the Clear key to stop printing the pattern. Press the On Line
key to return the printer to the Local menu status or press the
Clear key to move backwards up a level.
139
Chapter 6. Using the Maintenance Menu