Chapter 2. GETTING STARTED
PREPARING THE PRINTER FOR OPERATION
PUSH DOWN
TO LOCK
BRAKE TAB
Brake Tab on Front Caster
GEK-00028C
Printer unpacking is complete when all accessories have been
removed from the packaging and printer cabinet, and the shipping
blocks and hardware have been removed from the printer. See
Appendix A for instructions to unpack the printer from its packing
materials. Instructions to remove shipping blocks and hardware
follow this section.
Move the printer to a suitable operating location. See Appendix C for
considerations on the space and conditions required for normal
operation.
On the 5180 (52 dBa) Cabinet Model, two front casters have locks to
stabilize the printer once it has been moved to its location. Press one
brake tab to lock the wheel of the caster and press the other tab to
unlock. See Figure 2-1.
Figure 2-1
Each corner of the 5180 (55 dBa) Cabinet Model printer has a screw
down leveling pad near the wheel. Use the pads to level the printer on
uneven surfaces or to prevent the printer from rolling. See Figure 2-2
The printer should be initially setup following the instructions
given in this chapter, in the order presented.
PRESS TO UNLOCK
LEVELING PAD
Note
5
LEVELING PAD
Figure 2-2
Rear View of 5180
(55 dBa) Model
Chapter 2. Getting Started