Vertical Dpi; Slashed Zero; Clip Text - Genicom GEK-00027C User Manual

IGP

Vertical DPI

Vertical DPI
72<
IGP

Slashed Zero

Slashed Zero
Disable<
IGP

Clip Text

Clip Text
Disable<
GEK-00028C
Vertical DPI
This selects the Vertical DPI setting for IGP. This is used to specify
the Vertical Dots Per Inch. If set to 70 (72), a one-inch (1") high
character will be 70 (72) of an inch high.
1. While in the IGP menu, press the ◄ (left) or ► (right) menu
browse key until Vertical DPI is displayed in the lower right corner
of the LCD.
2. Press the ▼ (down) menu browse key to access the Vertical DPI
options.
3. Press the ◄ (left) or ► (right) menu browse key until the desired
option is displayed. Press the Select key to enable or disable an
option. The < symbol will immediately follow an enabled option.
Slashed Zero
This selects the Slashed Zero setting for IGP. When enabled, zero
characters will print as slashed zeros, e.g.. "Ø."
1. While in the IGP menu, press the ◄ (left) or ► (right) menu
browse key until Slashed Zero is displayed in the lower right
corner of the LCD.
2. Press the ▼ (down) menu browse key to access the Slashed Zero
options.
3. Press the ◄ (left) or ► (right) menu browse key until the desired
option is displayed. Press the Select key to enable or disable an
option. The < symbol will immediately follow an enabled option.
Clip Text
This selects the Clip Text (Excess Text Ignored) setting for IGP. When
enabled, any text that exceeds the IGP form length will not be
printed.
1. While in the IGP menu, press the ◄ (left) or ► (right) menu
browse key until Clip Text is displayed in the lower right corner of
the LCD.
2. Press the ▼ (down) menu browse key to access the Clip Text
options.
3. Press the ◄ (left) or ► (right) menu browse key until the desired
option is displayed. Press the Select key to enable or disable an
option. The < symbol will immediately follow an enabled option.
95
Chapter 5. Using the Set Up Menu