Replenishing Paper Supply; Setting Top Of Form - Genicom GEK-00027C User Manual

Replenishing Paper Supply

Online
Status

SETTING TOP OF FORM

5180 User's Manual
If the operator wants to change forms or paper:
1. With the printer in the online status, press the FF (form feed) key
to eject the remaining forms out of the upper tractors. (If Paper
Out is displayed in the upper left corner of the display window,
press FF (form feed) key to eject the remaining form out of the
upper tractors).
2. Load a fresh supply of paper/forms and return the print gap
wheel to the proper setting. See "Loading Paper" in Chapter 1.
↑ ↓
3. Use the and/or
perforation's position relative to the center marks on the upper
tractors.
4. Press TOF key and place the printer Online. (If necessary, see
Setting Top of Form below.)
5. Press the Clear key to clear the fault displays.
6. Press the On Line key to place the printer online.
Setting the top of form tells the printer where the top of form position
(perforation) is located on the paper.
Use the following procedures to set the top of form:
1. The paper perforation must first be positioned at the pointer on
each of the upper tractor doors. See Figure 3-1.
2. Position the paper using the
arrow keys to make final adjustments to the
↑
key and/or
34
↓
keys, if necessary.
GEK-00028C