Multisource - Genicom GEK-00027C User Manual

MultiSource

I/F Settings
MultiSource
Delay Seconds
006
GEK-00028C
This sub-menu is used to select the multiple interface option. In
multisource mode, all available interfaces are enabled. If received
data stops on the currently active port, the next port is checked for
received data after the "Delay Seconds" time has elapsed and no more
data has been received from the last port that received data.
1. While in the I/F Settings menu, press the ◄ (left) or ► (right)
menu browse key until MultiSource is displayed in the lower right
corner of the LCD.
2. Press the Select key to select MultiSource. Delay Seconds will be
displayed in the upper left corner of the display and the current
setting will be displayed in the lower right corner of the display.
Notice the cursor (underline) is now shown under the first digit
and the default number is 000. The four menu browse keys revert
to data entry operation. The horizontal ◄ ► (left or right) keys
position the cursor (underline) under the digit to be changed; the
vertical ▲ ▼ (up or down) menu browse keys
increment/decrement the selected digit by one.
3. Press the Clear key after all changes are complete and the
desired value is displayed in the lower right corner of the LCD.
The valid range of values for this option is 006 to 030. Pressing
the Clear key does not erase the values entered, but does allow
the user to exit the User Set menu.
Repeat this section if further changes are necessary.
Note
71
Chapter 5. Using the Set Up Menu