Retract; Horiz Tab - Genicom GEK-00027C User Manual

Retract

TearOff
Retract
Retract
Next TOF<

HORIZ TAB

Set Up
Horiz Tab
Horiz Tab
By Column
Hor Tabs Cols
01:008
Hor Tabs Cols
17:New
Hor Tabs Cols
17:000<
GEK-00028C
This menu is used to select the length of the paper retraction. Next
TOF will retract the paper to the TOF as currently set for the printer.
Full Return will retract the paper only the length of a line return that
is currently set for the printer.
1. While in the TearOff menu, press ◄ (left) or ► (right) menu
browse key until Retract is displayed in the lower right corner of
the LCD.
2. Press the ▼ (down) menu browse key to access the Retract
options.
3. Press the ◄ (left) or ► (right) menu browse key until the desired
option is displayed. Press the Select key to enable or disable an
option. The < symbol will immediately follow an enabled option.
This menu is used to set or clear horizontal tabs. The Horiz Tab
may be set By Column, By Inches, or Clear All Tabs.
The first two digits represent the tab ID and the last three digits
are the tab location. The number of tab IDs available is
dependent on the emulation selected. See "Horizontal/Vertical
Tab Id Maximum Slots" table in Appendix H.
1. While in Set Up menu, press ◄ (left) or ► (right) menu browse key
until Horiz Tab is displayed in the lower right corner of the LCD.
2. Press the ▼ (down) key to access the horizontal tab submenus.
Horiz Tab is displayed in the upper left corner of the LCD.
3. Press the ◄ (left) or ► (right) menu browse keys and select Clear
All Tabs, By Columns, or By Inches. Press the Select key to select
one of these options. Hor Tabs Cols, or Hor Tabs IN will be
displayed in the upper left corner of LCD.
4. The first 16 columns and inches settings are preset settings and
are selected using the Select key. The remaining settings are
user-set. (Press the Select key again to modify the horizontal tab
setting ). Notice the cursor (underline) is now shown under the
first digit and the default number is 000. The four menu browse
keys revert to data entry operation. The horizontal ◄ ► (left or
right) keys position the cursor (underline) under the digit to be
changed; the vertical ▲ ▼ (up or down) menu browse keys
increment/decrement the selected digit by one. Each time a user-
set tab is entered, it is associated with the tab ID that places it
chronologically in sequence. For example, by default the first
Horizontal tab 01: is set to 008. If the user enters a new tab
position of 001, it will be associated with tab ID 01: and 008 will
be moved to tab ID 02 and so on until the maximum horizontal
tab IDs are used.
Note
133
Chapter 5. Using the Set Up Menu