Loading Paper - Genicom GEK-00027C User Manual

Loading Paper

GEK-00028C
4. Lay the V-shaped paper stacking aid on the shelf between the
wickets. This stacking aid should be used when stacks of 1000 or
more forms are anticipated. See Figure 2-13.
Figure 2-13 "V" Shaped Metal Paper Stacking Aid
This printer is designed to use edge-punched (sprocket, or pin-fed)
fanfold paper. See "Paper Specifications" in Appendix B for further
description of the types of paper that can be used in the printer.
Printing without paper or using paper too narrow for the job may
damage printer components and void the printer warranty. Full-
width paper (greater than 14 5/8-inch or 371cm) should be used
until the operator is familiar with the printer's setup and
operation.
To load paper in the printer, complete the following steps:
1. Lift the top access door of the printer.
2. Turn the print gap wheel to the LOAD position by turning the
print gap wheel clockwise until it stops. See Figure 2-14.
PAPER TENSION
ADJUST LEVER
Figure 2-14 Print Gap Wheel
CAUTION
19
PRINT GAP WHEEL
IN LOAD POSITION
Chapter 2. Getting Started