Table of Contents
Advertisement
QMS
Ignore Mode
Ignore Mode
Disable<
QMS
Slashed Zero
Slashed Zero
Disable<
QMS
PY Terminator
PY Terminator
CR<
5180 User's Manual
Ignore Mode
This selects Ignore Mode (Ignore Data Mode) for QMS. When Ignore
Mode is enabled, all data received from the host is ignored until a ^A
(Ignore Mode OFF) Command is received. If this option is enabled, the
Code V option must also be enabled.
1. While in the QMS menu, press the ◄ (left) or ► (right) menu
browse key until Ignore Default is displayed in the lower right
corner of the LCD.
2. Press the ▼ (down) menu browse key to access the Ignore Default
options.
3. Press the ◄ (left) or ► (right) menu browse key until the desired
option is displayed. Press the Select key to enable or disable an
<
option. The
symbol will immediately follow an enabled option.
Slashed Zero
This selects the Slashed Zero setting for QMS. When enabled, zeros
are printed as slashed zeros, e.g.. "Ø."
1. While in the QMS menu, press the ◄ (left) or ► (right) menu
browse key until Slashed Zero is displayed in the lower right
corner of the LCD.
2. Press the ▼ (down) menu browse key to access the Slashed Zero
options.
3. Press the ◄ (left) or ► (right) menu browse key until the desired
option is displayed. Press the Select key to enable or disable an
option. The < symbol will immediately follow an enabled option.
PY Terminator
This selects either CR or CR LF as the ^PY Command Terminator for
QMS. The ^PY^- magnum on command should be terminated with
ASCII <CR><LF>. With this option set to LF, the <LF> is ignored. It
may also be terminated by a carriage return/linefeed combination.
The linefeed causes printing to begin on the second line of the
program. If printing on the first line is desired, set this option to CR.
1. While in the QMS menu, press the ◄ (left) or ► (right) menu
browse key until PY Terminator is displayed in the lower right
corner of the LCD.
2. Press the ▼ (down) menu browse key to access the PY Terminator
options.
3. Press the ◄ (left) or ► (right) menu browse key until the desired
option is displayed. Press the Select key to enable or disable an
option. The < symbol will immediately follow an enabled option.
100
GEK-00028C
Advertisement
Table of Contents
Troubleshooting
