Vertical Tabs; Emulation Vfu - Genicom GEK-00027C User Manual

Vertical Tabs

Type Select
Vertical Tabs<
Vertical Tabs
By Lines
Vert Tab Lines
01:New
Vert Tab Lines
01:000

Emulation VFU

Type Select
Emulation VFU
GEK-00028C
This menu is used to clear or set the vertical tab. The vertical tab
length may be set By Lines, By Inches or Clear All Tabs.
The first two digits represent the tab ID and the last three digits
are the tab location. The number of tab IDs available is
dependent on the emulation selected. See "Horizontal/Vertical
Tab Id Maximum Slots" table in Appendix H.
1. While in Type Select menu, press the ▼ (down) menu browse key.
Vert Tab will be displayed in the upper left corner of the LCD.
(This step assumes Vertical Tabs is the currently selected setting.
If not, press the Select key to select Vertical Tabs.)
2. Press the ◄ (left) or ► (right) menu browse keys and select Clear
All Tabs, By Lines,or By Inches. Press the Select key to select one
of these options. Vert Tab Lines, or Vert Tab IN will be displayed in
the upper left corner of the LCD.
3. Press the Select key again to modify the vertical tab setting.
Notice the cursor (underline) is now shown under the first digit
and the default number is 000. The four menu browse keys revert
to data entry operation. The horizontal ◄ ► (left or right) keys
position the cursor (underline) under the digit to be changed; the
vertical ▲ ▼ (up or down) menu browse keys
increment/decrement the selected digit by one.
4. Press the Clear key after all changes are complete and the
desired value is displayed in the lower right corner of the LCD.
Pressing the Clear key does not erase the values entered, but does
allow the user to exit the User Set menu.
Repeat this section if further changes are necessary.
This option sets the Vertical Format for an emulation-dependent
vertical format unit (VFU.) The VFU option is for all emulations
except Proprinter and FX286e. See the Programmer's Manual for
additional information.
Use the following procedure to select the Emulation VFU option:
While in Type Select menu, press the ◄ (left) or ► (right) menu
•
browse key until Emulation VFU is displayed in the lower right
corner of the LCD. Press Select to select Emulation VFU.
Note
Note
135
Chapter 5. Using the Set Up Menu