Basic Ip Commands; Config Ipif System - D-Link DGS-1100-06/ME Cli Reference Manual

The Basic IP commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command

config ipif system

show ipif
Each command is listed in detail, as follows:
config ipif System
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the DHCPv6 client state of the System interface to enabled:
DGS-1100-06/ME:5#config ipif System dhcpv6_client enable
Command: config ipif System dhcpv6_client enable
DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
Parameter
[dhcp | dhcp_option12 {clear_hostname | hostname <hostname 63> state
[enable | disable] } | ipaddress [<network_address> gateway <ipaddr>] | [ipv6
ipv6address <ipv6networkaddr>] | [dhcpv6_client [enable | disable]] ]
To configure the DHCPv6 client state for the interface.
config ipif System [dhcp | dhcp_option12 {clear_hostname |
hostname <hostname 63> state [enable | disable] } | ipaddress
[<network_address> gateway <ipaddr>] | [ipv6 ipv6address
<ipv6networkaddr>] | [dhcpv6_client [enable | disable]] ]
The config ipif system command is used to configure the DHCPv6
client state for one interface.
system − The IP interface name to be configured. The default IP
Interface name on the Switch is 'System'. All IP interface
configurations done are executed through this interface name.
dhcp − Specifies the DHCP protocol for the assignment of an IP
address to the Switch to use for the DHCP Protocol.
hostname <hostname 63> – Specifies the host name of DHCP.
ipaddress <network_address> − IP address and netmask of the IP
interface to be created. The address and mask information may be
specified
10.1.2.3/255.0.0.0 or in CIDR format, 10.1.2.3/16).
gateway <ipaddr> − IP address of gateway to be created.
state [enable | disable] − Enables or disables the IP interface.
ipv6 ipv6address <ipv6networkaddr> − IPv6 network address: The
address should specify a host address and length of network prefix.
There can be multiple V6 addresses defined on an interface. Thus,
as a new address is defined, it is added on this IP interface.
dhcpv6_client [enable | disable] − Enable or disable the DHCPv6
client state of the interface.
Only Administrator or operator-level users can issue this command.

BASIC IP COMMANDS

by using the traditional
134
format (for example,
21