Table 4.10-2 Combinations Of Bus Widths Available In Areas 4 And 5 - Fujitsu MB91F109 FR30 Hardware Manual

[bit 4] REFE (REFresh Enable bit)
The REFE bit specifies whether to perform the cyclic refresh operation of the CAS before
RAS (CBR) type. When starting the cyclic refresh, regardless of areas 4 and 5, set the
REFE bit of DMCR4 or DMCR5 to "1" and set the STR bit of the refresh control register
(RFCF).
0: Does not perform a cyclic refresh (initial value).
1: Performs cyclic refresh with an interval specified by the refresh control register (RFCR).
[bit 3] PAR (PARity select bit)
This device supports no parity function.
Setting this bit has no effect.
[bit 2] PERR (Parity ERRor bit)
This device supports no parity function.
Setting this bit has no effect.
[bit 1] PEIE (Parity Error Interrupt Enable bit)
The PEIE bit specifies whether to output an interrupt request for a parity error.
This device supports no parity function.
Be sure to set this bit to "0".
Bus Width Combinations
Table 4.10.2 lists the combinations of bus widths available in areas 4 and 5.

Table 4.10-2 Combinations of Bus Widths Available in Areas 4 and 5

Combination
1
2
3
4
5
6
7
8
9
Area 4
Usual: 16/8 bits
Usual: 16/8 bits
Usual: 16/8 bits
DRAM: 16 bits (C/W = 0, 1)
DRAM: 16 bits (C/W = 0, 1)
DRAM: 16 bits (C/W = 0, 1)
DRAM: 8 bits (C/W = 0, 1)
DRAM: 8 bits (C/W = 0, 1)
DRAM: 8 bits (C/W = 0, 1)
4.10 DRAM Control Register 4/5 (DMCR4/5)
Area 5
Usual: 16/8 bits
DRAM: 16 bits (C/W = 0, 1)
DRAM: 8 bits (C/W = 0, 1)
Usual: 16/8 bits
DRAM: 16 bits (C/W = 0, 1)
DRAM: 8 bits (C/W = 0, 1)
Usual: 16/8 bits
DRAM: 16 bits (C/W = 0, 1)
DRAM: 8 bits (C/W = 0, 1)
129