Table of Contents
Advertisement
10.10 Notes on Using the UART and Example for Using the UART
This section provides an example for use of the UART and notes on using the UART.
Notes on Using the UART
Set the communication mode while UART operation is stopped. Data transmitted during mode
setting cannot be assured.
If the timing for writing to the serial output data register (SODR) matches the timing for
requesting a receiver interrupt (RDRF = 1) during UART operation in synchronous transfer
mode (mode 2), the communication control circuit may stop. To prevent this problem, write to
the SODR after data transfer or immediately after transmission begins.
Example for Use of the UART
In mode 1, multiple slave CPUs are connected to one host CPU as shown in Figure 10.10-1.
This resource supports only the communication interface on the host end.
Host CPU
Communication begins with address data transfer by the host CPU.
Address data is indicated by the fact that the A/D bit of the SCR register is "1". Address data is
used to select the target slave CPU so that the host CPU can start to communicate with it.
Normal data is sent when the A/D bit of the SCR register is "0".
Figure 10.10-2 shows a flowchart for this operation.
Since the parity check function cannot be used in this mode, set the PEN bit of the SCR register
to "0".
10.10 Notes on Using the UART and Example for Using the UART
Figure 10.10-1 Sample System Structure for Mode 1
SO
SI
SO SI
Slave CPU#0
SO SI
Slave CPU#1
263
Advertisement
Table of Contents
