Disable Preempt - Dell Force10 S4810P Configuration Manual

Figure 55-9. Command Example:
FTOS(conf-if-gi-1/1-vrid-111)#authentication-type ?
FTOS(conf-if-gi-1/1-vrid-111)#authentication-type simple
Figure 55-10. Command Example: show config in VRID mode with a Simple Password Configured
FTOS(conf-if-gi-1/1-vrid-111)#show conf
!
vrrp-group 111
authentication-type simple 7
priority 255
virtual-address 10.10.10.1
virtual-address 10.10.10.2
virtual-address 10.10.10.3
virtual-address 10.10.10.10
FTOS(conf-if-gi-1/1-vrid-111)#

Disable Preempt

The
preempt
another router with a higher priority comes online.
Prevent the BACKUP router with the higher priority from becoming the MASTER router by disabling
.
preempt
Note: All virtual routers in the VRRP group must be configured the same: all configured with preempt
enabled or configured with preempt disabled.
Since preempt is enabled by default, disable the preempt function with the following command in the
VRRP mode. Re-enable preempt by entering the
display in the show commands, because it is a default setting.,
Task
Prevent any BACKUP router with a higher priority
from becoming the MASTER router.
Figure 55-11. Command Example:
FTOS(conf-if-gi-1/1)#vrrp-group 111
FTOS(conf-if-gi-1/1-vrid-111)#no preempt
FTOS(conf-if-gi-1/1-vrid-111)#show conf
1106
| Virtual Router Redundancy Protocol (VRRP)
authentication-type
387a7f2df5969da4
command is enabled by default, and it forces the system to change the MASTER router if
7 force10
Encryption type
(encrypted)
Encrypted password
command. When preempt is enabled, it does not
preempt
Command Syntax
no preempt
no preempt
Password
Command Mode
INTERFACE-VRID