Genlock Setup - Barco ScreenPRO-II User Manual

dÉåäçÅâ=pÉíìé
ScreenPRO-II Controller system setup: Step 13
13
In this procedure, you will set up Genlock for each destination selected on the Output
Menu . Please note:
•
•
Use the following steps to set up Genlock:
1.
2.
3.
4.
5.
6.
7.
8.
9.
ScreenPRO-II Controller • User's Guide
Prerequisites — Ensure that you are familiar with the Genlock Menu . In
Chapter 4, refer to the "
For Single Screen Destinations — if you elect to connect an external genlock
signal to ScreenPRO-II (and loop that signal from chassis to chassis), use this
procedure to select the genlock "type" and verify the current setting of each
ScreenPRO-II's Termination Switch .
For Widescreen Destinations — if you elect to connect an external genlock
signal to BlendPRO-II, use this procedure to select the genlock "type."
Important For Widescreen destinations, the Widescreen Lock and
External Genlock signals must be set according to the
procedures outlined in Chapter 3, in the "
Widescreen Lock Connections
From the Home Menu , press OUTPUT to display the Output Menu .
On the Destination Bus , select the destination that you want to configure.
{ }
Press GLCK to display the Genlock Menu .
For all types of destinations, on the Source line, set the genlock source, either
Black Burst , CSync or None .
For single screen destinations only, on the Termination line, verify the setting of
the ScreenPRO-II's Termination Switch .
{ }
Press BACK to return to the Output Menu .
Repeat from step 2 to set additional destination genlock types.
{ }
Press HOME to return to the Home Menu .
{ }
Press SAVE to save the new system configuration in memory.
Genlock Menu " section on page 103.
" section on page 77.
5. System Setup

Genlock Setup

BlendPRO-II
201