Barco ScreenPRO-II User Manual page 40

2. Hardware Orientation
Front Panel Sections
Next — press to recall the next valid Preset in sequential order. Please note:
•
Next
•
•
Previous — this function is currently not implemented.
Previous
Page — hold down Page , then press the desired Preset button to switch to that page of
Presets. The Red LED above the button lights to indicate the selected page.
Page
In Chapter 6, refer to the "
instructions on all Preset modes.
aÉëíáå~íáçåL^ìñ=_ìë
The figure below illustrates the Destination/Aux Bus :
DESTINATIONS / AUX
1
Figure 2-4. Destination/Aux Bus
Each numbered button on the Destination Bus represents a location to which you can
route some form of controller (or router) output. The transitions that you perform will affect
the selected destinations only, leaving the unselected destinations as they were. The
ScreenPRO-II Controller provides eight destinations — four standard (e.g., projectors) and
four Aux (auxiliary).
40
If Preset 2 is lit, pressing Next recalls Preset 3 .
If Preset 6 is active on page 2 , pressing Next advances to Preset 1 on page 3 .
If a Preset is undefined, it will be skipped when Next is pressed.
To switch to page 5, press Page + 5 .
Note The Page button is also used (in conjunction with the ALL
button) to lock and unlock the Controller. In Chapter 6, refer
to the "
page 252 for details.
Working with Presets
2 3 4
Important Operationally, remember that the Destination/Aux Bus is
one bus — it is not two separate and independent buses.
•
•
Locking and Unlocking the Controller
" section on page 243 for complete
DEST
ALL
AUX
Any source selection will apply to all enabled buses.
Any transition will apply to all enabled buses.
ScreenPRO-II Controller • User's Guide
" section on