Connection Charts; Connection Chart Overview; Sample Connection Charts - External Routing - Barco ScreenPRO-II User Manual

3. Hardware Installation

Connection Charts

`çååÉÅíáçå=`Ü~êíë=
The following topics are discussed in this section:
•
•
•
•
`çååÉÅíáçå=`Ü~êí=lîÉêîáÉï
A series of Connection Charts are provided on the following pages to assist with your
ScreenPRO-II input and output connections. Please note the following points:
•
•
•
Chart instructions:
•
56

Connection Chart Overview

Sample Connection Charts — External Routing
Sample Connection Charts — Internal Routing
Blank Connection Charts
Each ScreenPRO-II provides:
~
8 x analog inputs, scaled. These can be used to connect RGB,
composite, S-Video (Y/C) and component video.
~
2 x HD-SDI/SD-SDI inputs, scaled (on the HD model).
~
2 x DVI inputs, unscaled (BG/DSK).
You can connect sources directly to inputs ( internal routing ), or you can connect
router outputs to inputs ( external routing ). This assignment is performed on the
Destination Setup Menu . Note that the use of routers offers less restrictions with
regard to assigning sources to layers.
~
If you have configured a ScreenPRO-II to use internal routing , both the
white buttons (analog sources) and the yellow buttons (HD-SDI/SD-SDI
sources) are active on the Source Selection Bus . You can assign a
maximum of 16 analog and 2 HD-SDI/SD-SDI sources.
~
If you have configured a ScreenPRO-II to use external routing , only the
white source buttons on the Source Selection Bus are active. You can
assign a maximum of 16 sources, using any mix of analog and digital.
Important In this mode, with external routing enabled, the two yellow
SDI buttons are disabled.
On each ScreenPRO-II, two DVI connectors are provided for Background and
DSK Inputs . Both connectors are digital only, and do not include analog pins.
Please note:
~
To use two background sources, connect one source to connector A and
one to connector B .
~
To use one background and one DSK source, connect the background to
connector A and the DSK source to connector B .
Analog Router I/O Chart
If you are using external routing, complete the Analog I/O router chart for your
analog input and output connections. The chart can also be used to specify router
outputs that connect to Aux destinations.
ScreenPRO-II Controller • User's Guide