Barco ScreenPRO-II User Manual page 184

5. System Setup
Setup Prerequisites
pÉíìé=mêÉêÉèìáëáíÉë
Before starting to set up your ScreenPRO-II Controller system, please review the following
important prerequisites:
•
•
•
•
•
Please note:
•
•
Figure 5-1. Menu Navigation
184
Ensure that you are familiar with all ScreenPRO-II Controller system hardware,
including all Controller sections, and the functions of all buttons within the
sections. Refer to Chapter 2, "
Ensure that hardware is properly installed, and that all sources, routers and
peripherals are properly connected. Refer to Chapter 3, "
on page 53 for details.
If you will be using a widescreen configuration, ensure that all " Widescreen Lock "
connections to/from BlendPRO-II are properly installed. In Chapter 3, refer to the
" BlendPRO-II Widescreen Lock Connections
Ensure that you are familiar will all ScreenPRO-II Controller menus and sub-
menus. Refer to Chapter 4, "
Ensure that your connection charts are complete, and readily available for
reference throughout this chapter. In Chapter 3, refer to the "
section on page 56 for details.
In this chapter, when a procedure tells you to " scroll to " a certain line, use the
rotary knob labelled NAV to move the highlight.
When a procedure tells you to " adjust " or " select " a certain parameter, use the
ADJ rotary knob.
674
452
-34
70
0.8
[ LINEAR ]
Hardware Orientation
" section on page 77 for details.
Menu Orientation " on page 85 for details.
N
A
V
A
D
J
ScreenPRO-II Controller • User's Guide
" on page 31 for details.
Hardware Installation
Connection Charts
"
"