Barco ScreenPRO-II User Manual page 42

2. Hardware Orientation
Front Panel Sections
All — the All button works in conjunction with the currently selected bus (as chosen with
the DEST/AUX button):
All
•
•
In Chapter 6, refer to the "
instructions on all destination modes.
gçóëíáÅâ=pÉÅíáçå
The figure below illustrates the Joystick Section .
Source
Top
Left
Reset
Figure 2-5. Joystick Section
When a PIP or Key is selected in the Layer Control Section , the controls in the Joystick
section are automatically assigned to manipulate that feature on Preview. When none of
the six function buttons are lit, the 3-axis Joystick has the following functions:
•
•
•
42
Press All once to turn all "defined" destinations on.
Double-punch the All button to turn all "defined" destinations off.
Note The All button is also used (in conjunction with the Page
button) to lock and unlock the Controller. In Chapter 6, refer
to the "
page 252 for details.
Working with Destinations
Adjustment Panel
Crop
Bottom
Right
Fine
Adjust
X-Axis Control — Move the Joystick left and right to move the PIP (or Key) left
and right respectively.
Y-Axis Control — Move the Joystick up and down to move the PIP (or Key) up
and down on Preview.
Z-Axis Control — Twist the Joystick's top knob clockwise and counterclockwise
to increase or decrease the PIP (or Key) size.
Note The Z-Axis Control can also be used to increase or
decrease the value of a highlighted parameter, such as a
matte color, key clip and gain, border size and much more.
Locking and Unlocking the Controller
" section on page 222 for complete
ScreenPRO-II Controller • User's Guide
" section on