Input Setup; Standard Input Setup; Widescreen Phase And Color Balance Setup - Barco ScreenPRO-II User Manual
Hide thumbs
Also See for ScreenPRO-II:
- Brochure (4 pages) ,
- Brochure & specs (6 pages) ,
- User manual (206 pages)
Table of Contents
Advertisement
5. System Setup
Input Setup
6.
7.
8.
9.
10. Press
fåéìí=pÉíìé
ScreenPRO-II Controller system setup: Step 16
16
In these procedures, you will set up the system's inputs, and adjust phase and color
balance for wide screen configurations only. The following procedures are provided:
•
•
pí~åÇ~êÇ=fåéìí=pÉíìé
Use the following steps to set up inputs. This procedure applies to both single screen
and widescreen destinations.
1.
2.
3.
4.
5.
6.
7.
206
To configure a frame grab background:
a.
Ensure that you have captured a still frame, either from a live DVI
background or from one of the two layers ( LAYER A or LAYER B ). In
Chapter 6, refer to the "
for instructions.
b.
Scroll to the Type line and select FG_1 , FG_2 or FG_3 .
{
}
c.
Press
SAVE
.
Repeat from step 3 for BG B .
Repeat from step 2 for the next destination's background sources that you want to
configure.
When all background sources have been configured for all destinations, press
{
}
HOME
to return to the Home Menu .
{
}
SAVE
to save the new system configuration in memory.
Prerequisites — Ensure that you are familiar with the Input Menu . In
Chapter 4, refer to the "
Standard Input Setup
Widescreen Phase and Color Balance Setup
On the Destination Bus , select the destination whose inputs you want to
configure.
On the ScreenPRO-II Controller console, select a layer ( LAYER A or LAYER B ).
{
}
Press
HOME
to display the Home Menu .
Press INPUT to display the Input Menu .
On the Source Selection Bus , select the first source that you want to set up.
{
Press
FORCE ACQUIRE
Perform additional setups on the Input Menu — if required :
a.
If you need to manually set the resolution, scroll to the Format line and
select the desired format. Press
b.
Scroll to the Sampling Mode line and set the sampling mode.
c.
Scroll to the Contrast line and set the input's contrast.
d.
Scroll to the Brightness line and set the input's brightness.
Working with Still Frames
Input Menu
" section on page 88.
}
to perform the optimum image setup.
{ APPLY FORMAT }
ScreenPRO-II Controller • User's Guide
" section on page 246
to accept.
Advertisement
Table of Contents
