Table of Contents
Advertisement
Take care not to use the entry »default settings« as this applies other settings than
mentioned above. Nevertheless if so, please readjust the BIOS to the above Hydra Compact
settings!
4.1.3 Boot agent settings
For the single board computer SBC/2 it is important that the boot agent uses correct settings to prevent it to try
to boot from the network, which would increase startup time of the H
configured in your H
YDRA
readjust the settings.
The settings of the boot agent of the SBC/2
path
Network Boot Protocol
Boot Order
Show Config Message
Show Message Time
After readjusting the settings, press the F4 key to save the changes and quit.
4.1.4 Finishing the setup of BIOS and boot agent
•
After selecting the appropriate settings save the settings and exit the BIOS or boot agent setup.
•
Halt the H
C
YDRA
OMPACT
•
Now you can safely disconnect monitor and keyboard from the SBC.
•
The H
C
can be taken into its usual operation again.
YDRA
OMPACT
Barco – Hydra Compact – R5976568 – Revision 12 – May-2005
C
. In case they have been changed, please use the table below as a reference to
OMPACT
and switch it off again, please see above.
____________________________________________________________________________________________________
C
. These settings are pre-
YDRA
OMPACT
setting
PXE
Int 18h
Enable
3 Seconds
Realtek boot agent settings
4. Operating
Table 4-3
4-3
Advertisement
Table of Contents
