Barco ScreenPRO-II User Manual page 89

fåéìí=jÉåì=aÉëÅêáéíáçå
The figure below illustrates the Input Menu :
H
O
M
E
C
F
G
A
R
S
A
V
E
Figure 4-3. Input Menu (sample)
The Input Menu is used to adjust all parameters relating to dedicated and routed inputs,
including the physical sources connected to individual ScreenPRO-II units. The menu
enables you to set all configuration options for the selected input.
To access the menu:
•
•
•
The currently selected input appears in the menu's upper right corner. The menu tracks the
selected input, thus, if you switch inputs on the Source Selection Bus , the menu is
immediately re-assigned to the new input.
ScreenPRO-II Controller • User's Guide
INPUT MENU
Destination
ID
Layer
Input Connector
Format 1024 x 768 @ 60
Input Type
Color Space
Sampling Mode
Contrast < % >
APPLY
SIZING
FORMAT
Press a blue layer button in the Layer Control Section (the button blinks).
Select an input on the Source Selection Bus (the button blinks).
Press INPUT on the Home Menu .
Note The menu cannot be accessed without a selected layer. An
error message will be shown.
Important From a conceptual standpoint, there are no "direct"
connections to a ScreenPRO-II scaler. All connections,
whether they are from a single source or an external router,
connect to the internal router matrix of each ScreenPRO-II.
4. Menu Orientation
SRC_1
1
1
[ A ]
HD-15
[ RGB ]
[ RGB ]
1:1
100.0
COLOR FORCE
BALANCE ACQUIRE
Input Menu
N
A
V
A
D
J
89