Barco ScreenPRO-II User Manual page 203

13. Repeat from step 2 for additional single screen destination projector setups.
14. Press
15. Press
táÇÉ=pÅêÉÉå=mêçàÉÅíçê=pÉíìé
Use the following steps to set up projectors for a wide screen application.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Press
11. Scroll to the Total H Res line and enter the total number of horizontal pixels in the
12. Scroll to the Background Format line and select the method by which your
13. Scroll to the Marker Mode line and enable (or disable) the system's wide screen
ScreenPRO-II Controller • User's Guide
{ }
HOME to return to the Home Menu .
{ }
SAVE to save the new system configuration in memory.
Note This procedure affects all projectors assigned to the selected
wide screen configuration.
If you elected to use the Configurator application to assist with your widescreen
setup parameters, ensure that you have completed the following steps:
a. On the Configurator's Show Layout Tab , click the radio buttons for the
ScreenPRO-II Controller and your desired show layout.
b. On the Configurator's Screen Details Tab , click the large " W " to display
the Wide Screen Parameters Window .
c. In the Wide Screen Parameters Window , enter your screen's H and V
dimensions and the number of projectors.
d. Click Calculate to determine the required overlap.
e. Make a note of these values. You will transfer them to the Controller's
Wide Screen Settings Menu in the following steps.
From the Home Menu , press OUTPUT to display the Output Menu .
On the Destination Bus , select your system's wide screen destination.
{ }
Press TEST PATTERN to display the Test Pattern Menu .
On the Output Monitor line, select the output(s) on which you want a test pattern
to appear — All , Preview , SPII Program or BPII Program .
On the Mode line, select On .
On the Type line, select the Burst test pattern.
On the Raster Box line, select On .
{ }
Press BACK to return to the Output Menu .
{ }
WIDE SCREEN to display the Wide Screen Settings Menu . Note that
the Total Projectors line shows the total number of ScreenPRO-II units that you
defined in the wide screen configuration (on the Destination Setup Menu ).
overall wide screen display.
background graphics were originally produced: Edge-butted or Overlapped .
markers, to show the boundaries of active data.
Note As required, you can change the Marker Mode value during
operations without affecting other wide screen settings.
5. System Setup
Projector Setup
203