Barco ScreenPRO-II User Manual page 32

2. Hardware Orientation
ScreenPRO-II Controller Rear Panel
pÅêÉÉåmolJff=`çåíêçääÉê=oÉ~ê=m~åÉä
The figure below illustrates the ScreenPRO-II Controller rear panel:
KEYBOARD
TALLY
1
7 2
Figure 2-1. ScreenPRO-II Controller Rear Panel
1) Keyboard Port
2) Tally Connector
3) Memory Card Slot
Following are descriptions of each rear panel connector and section.
1)
2)
3)
32
3
MEMORY CARD
4) Ext Comm Port
5) Console Port
6) Ethernet Port
Keyboard Port
On the optional Tally board, one standard PS-2 connector is provided for the
Keyboard Port . When a customer-supplied keyboard is connected, users can
enter system values and names.
Tally Connector
On the optional Tally board, one 25-pin D connector is provided for issuing tally
"relay closure" commands to external devices such as cameras. Eight tally
circuits are provided. In Appendix A, refer to the "
page 262 for pinout details.
Memory Card Slot
One Memory Card Slot is provided for a customer supplied Flash Memory Card ,
which enables users to externally store and recall system configurations — one
configuration per card. The minimum size card that the system accepts is 512
MB. The card also enables users to transfer configurations between Controllers
as required. In Chapter 6, refer to the "
page 253 for instructions.
4
EXT COMM
CAUTION: FOR CONTINUED PROTECTION
AGAINST RISK OF FIRE, REPLACE ONLY
ETHERNET
CONSOLE
WITH SAME TYPE AND RATING OF FUSE
5 6
7) Adjustable Feet
8) AC Connector and Fuse
Tally Connector
Using Backup and Restore
ScreenPRO-II Controller • User's Guide
T250V 2A FUSE
8
7
" section on
" section on