Using Move; Programming Moves; Program A Move On Preview - Barco ScreenPRO-II User Manual

6. Operations

Using Move

rëáåÖ=jçîÉ
The following topics are discussed in this section:
•
•
•
mêçÖê~ããáåÖ=jçîÉë
The ScreenPRO-II Controller enables you to move a PIP or a Key (or both) smoothly from
one screen location to another at a predefined rate, while the layer(s) are on-air. All moves
Move
are two-keyframe effects, with a starting location and an ending (destination) location.
Setup
There are two ways to program a move — on Preview or on Program .
•
•
Move
mêçÖê~ã=~=jçîÉ=çå=mêÉîáÉï
This mode enables you to program a move with the layer on Preview only — before it has
transitioned to Program.
Use the following steps to program a move on Preview:
1.
2.
3.
4.
5.
6.
7.
8.
To pend and trigger the move, refer to the "
page 239.
238

Programming Moves

Pending and Triggering Moves
Move Notes

Program a Move on Preview

Program a Move on Program
In the Layer Control Section , select the layer that you want to move ( LAYER A
or LAYER B ). The button blinks to indicate that it is active for modification.
In the Layer Functions Section , select Key or PIP as desired.
Size and position the PIP or Key in its "starting" location on Preview. Adjust all
border, shadow and source parameters in the normal way.
In the Layer Functions Section , press Move Setup . The button blinks to
indicate that you are now actively defining the properties of the move.
Move the PIP or Key to its "ending" size and location (on or off screen).
To define the rate at which the PIP or Key moves, adjust the Move Rate
parameter. The rate can be adjusted in 0.1 second increments.
Press Move Setup again to complete the programming. The button remains lit,
and the PIP or Key returns to its starting location on Preview.
Note The lit Move Setup button indicates an association between
the selected layer and a programmed "move." If you select a
different layer that does not have an associated move, the
button turns off. If you return to the "associated" layer, the
button lights again.
To set up an additional move on the other layer (provided that you are in Split
Layer mode), repeat the procedure from step 1 .
Pending and Triggering Moves
ScreenPRO-II Controller • User's Guide
" section on