Ethernet Upgrade Method - Barco ScreenPRO-II User Manual

`K==réÖê~ÇáåÖ=pçÑíï~êÉ

Ethernet Upgrade Method

bíÜÉêåÉí=réÖê~ÇÉ=jÉíÜçÇ
Use the following steps to upgrade ScreenPRO-II Controller software using an
Ethernet connection to your PC:
1.
2.
3.
4.
5.
Figure C-2. Flash Loader Utility
6.
Figure C-3. Ethernet Connection Dialog (sample)
7.
274
Note
The default IP address is 192.168.0.2 .
Ensure that your PC (or laptop) uses the Windows
systems.
Connect the ScreenPRO-II Controller's Ethernet port to a Hub or Switch.
Connect the Ethernet Hub or Switch to your PC. Remember that a totally "local"
network is recommended, without IP connections to the outside world.
Power-up the ScreenPRO-II Controller.
On the PC, click Start > Programs > Barco Folsom > ScreenPRO-II Controller
Software #.## > Flash Loader to launch the Flash Loader utility.
Click Communication > Ethernet > Connect to display the Ethernet
Connection Dialog .
Note If the Ethernet menu pick is grayed out, set the COM port to
None .
In the dialog, enter ScreenPRO-II Controller's IP address ( 192.168.0.2 ), and enter
the default port number: 3000 .
®
2000 or XP operating
ScreenPRO-II Controller • User's Guide