Barco ScreenPRO-II User Manual page 51

2. Hardware Orientation
CUT — press to instantly cut the images from Preview to Program.
CUT
Auto Trans — press to transition automatically from Preview to Program at a pre-defined
rate, using the selected transition type ( MIX or WIPE ). Auto transition rates are defined
AUTO
using the Effects Menu .
TRANS
T-Bar — enables you to perform smooth, manual transitions. Each time the T-Bar is
moved from limit to limit, the setup on Preview transitions to Program using the selected
transition type ( MIX or WIPE ).
For additional information on transitions and the Effects Menu :
•
•
ScreenPRO-II Controller • User's Guide
Note Because the Controller's Effects Menu is destination-based,
WIPE and MIX effects can be assigned per destination.
For example, with destinations 1 and 3 lit, select WIPE . Next,
with destination 2 lit, select MIX . Next, select all three
destinations and press AUTO TRANS to perform a wipe on
destinations 1 and 3, and a dissolve on destination 2.
In Chapter 4, refer to the "
In Chapter 6, refer to the "
operational procedures.
Effects Menu " section on page 146 for menu details.
Working with Transitions
Front Panel Sections
" section on page 241 for
51