Barco ScreenPRO-II User Manual page 204

5. System Setup
Projector Setup
14. Scroll to the Overlap Width line and enter the desired overlap (in pixels) between
15. Scroll to the Data Doubling line and enable or disable data doubling as required
16. Scroll to the Justification line and set the desired wide screen justification, either
17. In the Feathering section, scroll to the Mode line and enable or disable edge
18. Scroll to the Gamma line and set the gamma for the feathered regions as desired.
19. At each projector, perform the following adjustments to ensure that the output data
20. Press
21. Press
22. On the Type line, select one of the many Gray Scale test patterns, as desired.
23. At each projector, adjust color balance, brightness and contrast.
24. Once each projector is properly set, scroll to the Alignment Test Pattern line and
25. Press { BACK } to return to the Output Menu.
26. Press
27. Press
204
projectors.
for your configuration.
Center or Left .
feathering as required for your configuration.
The default value is 2.2 .
is properly displayed:
~
Adjust the images for a minimum amount of noise.
~
Adjust the pixel clocks for proper image position, such that the entire
Raster Box is visible.
{ }
BACK to return to the Output Menu .
{ }
TEST PATTERN to display the Test Pattern Menu .
Important Refer to your projector's technical manual for information on
all projector setup and adjustment procedures.
enable the function. This special test pattern allows you to perform projector lens
shift and registration adjustments.
a. At each projector, perform lens shift and registration adjustments.
b. If required, adjust the horizontal and vertical "totals" to match those
entered on the Wide Screen Settings Menu .
Note Refer to your projector's technical manual for information on
all lens shift and registration procedures.
c. When adjustments are complete, turn off the Alignment Test Pattern .
{ }
HOME to return to the Home Menu .
{ }
SAVE to save the new system configuration in memory.
ScreenPRO-II Controller • User's Guide