Saving The Setup - Barco ScreenPRO-II User Manual

p~îáåÖ=íÜÉ=pÉíìé
ScreenPRO-II Controller system setup: Step 19
When all system setup procedures have been complete, press { HOME } to display the
19
Home Menu , then press
volatile memory.
Once pressed, the Touch Screen menu reads " Saving System Configuration ." If you
cycle power, the Controller will return to its state at the time of the "save."
_~Åâìé=íç=cä~ëÜ=jÉãçêó=`~êÇ
ScreenPRO-II Controller system setup: Step 20
20
In this procedure, you will back up your system configuration to a Flash Memory Card .
Use the following steps to back up your system:
1.
2.
3.
4.
5.
6.
7.
8.
ScreenPRO-II Controller • User's Guide
{ }
SAVE . This action saves the state of the Controller in non-
Prerequisites — Ensure that you are familiar with the Backup/Restore
Menu . In Chapter 4, refer to the "
page 141.
Note You can only store one system configuration on a Flash
Memory Card.
Ensure that you have a (customer supplied) Flash Memory Card available.
Insert the Flash Memory Card into the Controller's rear panel Memory Card slot.
From the Home Menu , press MISC to display the Miscellaneous Menu .
Press { BACKUP RESTORE } to display the Backup/Restore Menu .
On the Device line, select Ctrlr+SP to perform a complete "backup."
On the Controller Options line, select All .
Press { CHECK CARD } to check for the presence of a Flash Memory Card.
Press { BACKUP } to perform a backup operation to the Flash Memory Card using
the selected device(s) and options.
5. System Setup
Backup/Restore Menu " section on

Saving the Setup

213