Barco ScreenPRO-II User Manual page 247

6. Operations
`~éíìêáåÖ=píáää=cê~ãÉë=Ñêçã=~=_~ÅâÖêçìåÇ=fåéìí
Use the following steps to capture a still frame from a background input:
1.
2.
3.
4.
5.
6.
7.
8.
Please note:
•
•
`~éíìêáåÖ=píáää=cê~ãÉë=Ñêçã=~=i~óÉê
Use the following steps to capture a still frame from a layer.
1.
2.
3.
4.
ScreenPRO-II Controller • User's Guide
Ensure that the background input from which you want to capture a still is properly
set up as a DVI input. In Chapter 5, refer to the "
page 205 for instructions.
Ensure that BG A , BG B or the DSK are not on Program. If they are, you will get
a pop-up prompt. Transition these layers off Program in the normal manner.
If you want to capture from BG B , ensure that the DSK is not in use.
In the Layer Control Section , select the background from which you want to
capture a still. The button blinks, the source appears on Preview, and the
selected Background Input Setup Menu appears.
Press { HOME } > { FRAME GRAB } to display the Frame Grab Menu .
On the Frame Number line, select the temporary frame store into which the still
will be captured ( FG_1 , FG_2 or FG_3 ).
Press { CAPTURE }. Once pressed, the screen will indicate that the frame is being
captured. A pop-up message confirms the procedure.
Repeat the procedure from step 4 to capture additional stills from a background
input. Remember that you can always overwrite FG_1 , FG_2 or FG_3 .
The captured still(s) can now be assigned as the input "type" for BG A , BG B , the
DSK or the LOGO . In Chapter 5, refer to the following sections for instructions:
~
" Background Setup
~
" DSK Setup Procedure
~
" LOGO Setup Procedure
Captured stills reside in temporary memory. If the system is powered down or
reset, the stills will be lost. To save stills in permanent memory, refer to the
" Saving Still Frames in Permanent Memory
Note Only "saved" still frames can be named.
Ensure that BG A , BG B or the DSK are not on Program. If they are, you will get
a pop-up prompt. Transition these layers off Program in the normal manner.
In the Layer Control Section , select the layer from which you want to capture a
still. The button blinks indicating that it is "selected."
Note The layer can be on Program or Preview.
Select PIP or Key in the normal manner. The selected PIP or Key Adjustment
Menu appears.
Adjust the PIP or Key's size and position. Remember that:
Background Setup
," page 205.
," page 211.
," page 212.
" section on page 248.
Working with Still Frames
" section on
247