Barco ScreenPRO-II User Manual page 33

2. Hardware Orientation
4)
5)
6)
7)
Figure 2-2. Controller Side View, showing adjustable feet retracted and extended
8)
ScreenPRO-II Controller • User's Guide
Ext Comm Port
One 9-pin D Ext Comm connector is provided for RS-232 communications with a
serial device, such as a router. The port is configured as follows:
~
DCE, 115K baud, 8 data bits, 1 stop bit, no parity bits
In Appendix A, refer to the "
Console Port
One 9-pin D connector is provided for RS-232 "command line" communications
with the ScreenPRO-II Controller, and for downloading code in the field. The port
is configured as follows:
~
DCE, 115K baud, 8 data bits, 1 stop bit, no parity bits
The serial port can be connected to a standard PC serial port with a straight
through DB-9 to DB-9 cable. In Appendix A, refer to the "
section on page 261 for pinout details.
Ethernet Port
One RJ-45 connector is provided for 10/100BaseT Ethernet communications with
the ScreenPRO-II Controller. When (optionally) connecting the Controller to
peripheral devices (such as BlendPRO-II), a standard Ethernet hub or switch on
an isolated network is recommended.
The Ethernet port is 10/100 Mbit auto sensing capable, and is configured to run as
a DHCP server. A variety of Barco Folsom protocols for communication, control,
and code loading are implemented. The Ethernet connector is compatible with:
~
Standard RJ-45 Ethernet cables
~
Neutrik EtherCon
In Appendix A, see the " Ethernet Connector
Adjustable Feet
The two rear feet of the ScreenPRO-II Controller are adjustable, enabling you to
raise the rear of the Controller for increased Touch Screen visibility.
AC Connector and Fuse
One AC Connector with integral Fuse is provided to connect the ScreenPRO-II
Controller to your facility's AC power source. Please note:
~
The integral switch turns the chassis on and off.
~
The fuse rating is T250V, 2A. For continued protection against risk of
fire, replace only with a fuse of the same type and rating.
ScreenPRO-II Controller Rear Panel
Serial Connector " section on page 261 for pinouts.
®
series cables
" section on page 260 for pinouts.
Serial Connector "
33