Barco ScreenPRO-II User Manual page 50

2. Hardware Orientation
Front Panel Sections
Split — press to select whether or not the mixer's two layers work independently (in Split
Mode ), in tandem ( Mix Mode ), or in " Join " mode.
Split
•
•
•
In Chapter 6, refer to the "
qê~åëáíáçå=pÉÅíáçå
The figure below illustrates the Transition Section .
TRANSITIONS
WIPE
Figure 2-9. Transition Section
Descriptions of each button and control are provided below:
WIPE — press to select a wipe as the current transition type for the selected destination.
The button lights when enabled, and the wipe is initiated by pressing AUTO TRANS . The
WIPE wipe patterns, edge types and transition rates are selected using the Effects Menu .
MIX — press to select a mix (dissolve) as the current transition type for the selected
destination. The button lights when enabled, and the mix is initiated by pressing AUTO
MIX TRANS . Auto transition rates are defined using the Effects Menu .
50
Mix Mode — the Split Layer button is off. In this mode, the two layers are
ganged together, offering a variety of additional transitions including the toggle,
mix source and swap functions.
Split Mode — the Split Layer button is on. In this mode, each layer works
independently. You have the freedom to size, position, manipulate and transition
each one independently of the other.
Join Mode — the Split Layer button is on. The currently blinking layer button is
considered the "master." Press and hold the Split Layer button, then press the
other (non-blinking) layer button to "join" the two layers together. Both layer
buttons blink, and in this mode, both are now joined together.
~
Any manipulation that you perform to the "master" layer is also
performed to the joined layer. Both can be sized, positioned, moved and
manipulated as if they are one.
~
To un-join the two layers, press and hold the Split Layer button, then
press either Layer button.
Working with Layers
MIX CUT
TRANS
" section on page 226 for details.
AUTO
ScreenPRO-II Controller • User's Guide