Barco ScreenPRO-II User Manual page 236

6. Operations
Working with Layer Functions
4.
5.
6.
7.
rëáåÖ=pï~é=wJlêÇÉê
Use the following steps to swap the Z-Order (priority) of two layers within the same
mixer. The function works with two Keys, two PIPs, or one of each.
Swap
Z-order 1.
2.
3.
rëáåÖ=cêÉÉòÉ
Use the following steps to freeze a layer's motion on both Program and Preview. This
function is useful for PIPs and Keys that use video and animated graphics.
Freeze
1.
2.
3.
Please note:
•
•
236
Select the desired clone type — Mirror or Offset .
If Offset is selected, adjust the offset (in pixels) as desired.
If desired, clone the other layer by repeating the procedure from step 1 .
Press CUT or AUTO TRANS to transition the effect to Program.
Note You can set up and perform a Move in conjunction with a
cloned image.
Ensure that you have two layers visible on Preview, with one layer visually
overlapping the other.
In the Layer Functions Section , press Swap Z-Order . The visual priority (on
Preview) of the two layers changes. Note that the layers remain at their current
locations — only the priority changes.
Transition the new "look" to program with a CUT or AUTO TRANS .
In the Layer Control Section , activate the layer that you wish to freeze. The
button blinks to indicate it is active.
In the Layer Functions Section , press Freeze to freeze the layer on both
Preview and Program (if applicable). The button lights to indicate that a "freeze"
is associated with the current layer.
Note The lit Freeze button indicates the association between the
selected layer and the "freeze." If you select a different layer
that does not have an associated freeze, the button turns off.
If you return to the associated layer, the button lights again.
With the layer selected, turn off the Freeze button to restore source motion.
If a source is on Program, selecting its layer and pressing Freeze will freeze the
image on Program.
You can also use Freeze if the PIP or Key is only on Preview, and then transition
the frozen image to Program.
ScreenPRO-II Controller • User's Guide