Programming Edid - Barco ScreenPRO-II User Manual

5. System Setup

Programming EDID

mêçÖê~ããáåÖ=bafa
ScreenPRO-II Controller system setup: Step 5
In this procedure, you will program EDID (Extended Display Identification Data), as a
5
prerequisite for background and DSK setup. The procedure guarantees proper
communications at the preferred resolution between each ScreenPRO-II's DVI inputs and
your system's PCs.
Use the following steps to program each ScreenPRO-II's EDID:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Once EDID programming is complete, reconnect each external computer and
11. On each PC's desktop, right-click to display the Display Properties Window .
12. Select the Settings Tab , and verify that the PC's resolution matches that which
13. If you selected an individual destination in step 6 , repeat steps 6 through 12 for
190
Prerequisite — Ensure that you are familiar with the EDID DVI Input Format
Menu . In Chapter 4, refer to the "
page 137.
Ensure that ScreenPRO-II output format matches your projector's native
resolution. In Chapter 4, refer to the "
page 102 for output format information.
Ensure that the computer(s) or external equipment that you wish to use as
background and DSK source(s) are capable of supporting the selected output
resolution.
Ensure that all DVI inputs to each ScreenPRO-II are disconnected.
On the Home Menu , press MISC to access the Miscellaneous Menu .
Press { EDID } to display the EDID DVI Input Format Menu .
On the Destination line, select the individual destination who's EDID you wish to
program, or select ALL if all destinations will be using the same resolution.
Note the Current line, which displays the current EDID video format that resides
in memory. If this format is already set to the desired resolution, no programming
is required. You can exit this procedure, and continue with other setup steps.
If a new resolution is required, scroll to the Format line and use the ADJ knob to
select the preferred EDID format.
Press { PROGRAM EDID }. A warning message will be shown. Press
{ CONTINUE } to continue with the procedure.
power it back on.
you just programmed into EDID. If not, set the resolution as required.
each remaining destination.
EDID DVI Input Format Menu
Output Menu Functions " section on
ScreenPRO-II Controller • User's Guide
" section on