Barco ScreenPRO-II User Manual page 47

2. Hardware Orientation
Move Setup — two functions are provided:
•
Move
Setup
•
In Chapter 6, refer to the "
Move — press to pend a "move" for a PIP or Key, enabling you to fly the PIP or Key from
one location to another on the next auto transition.
Move
In Chapter 6, refer to the "
Mix Source — in " Mix Mode " (with the Split button off) press Mix Source to co-locate both
PIPs in the mixer. Layers A and B will be exactly the same size — in exactly the same
Mix
position. Mix Source and Swap modes are mutually exclusive. In Chapter 6, refer to the
Source
" Understanding Split and Mix Modes
Swap — in " Mix Mode " (with the Split button off) press Swap to allow both PIPs in the
mixer to be located independently. Layers A and B can be positioned and sized anywhere
Swap as desired. Mix Source and Swap modes are mutually exclusive. In Chapter 6, refer to
the " Understanding Split and Mix Modes
Toggle — press to toggle sources back and forth with each transition. Once a source
transitions off Program within a PIP, it "flip-flops" to Preview. Toggle is used with both the
Toggle Mix Source and Swap modes, and also functions with background transitions. In
Chapter 6, refer to the "
details.
Freeze — enables you to freeze a layer on both Program and Preview.
In Chapter 6, refer to the "
Freeze
ScreenPRO-II Controller • User's Guide
Press Move Setup to set up a "move" for a PIP or Key, enabling you to choose
the move's start and end points.
Double-punch the Move Setup button to un-define (or clear) the "move setup" for
the selected layer.
Using Move
Using Move
Understanding Split and Mix Modes
Using Freeze
" section on page 238 for complete instructions.
" section on page 238 for complete instructions.
" section on page 228 for instructions.
" section on page 228 for instructions.
" section on page 228 for
" section on page 236 for instructions.
Front Panel Sections
47