Barco ScreenPRO-II User Manual page 117

aÉëíáå~íáçå=pÉíìé=jÉåì
From the System Menu , press
B
A
C
K
Figure 4-24. Destination Setup Menu (sample)
The Destination Setup Menu enables you to define each destination. The following
functions are provided:
•
•
ScreenPRO-II Controller • User's Guide
{
DEST SETUP
DESTINATION SETUP
Destination
Type
SP to Add
SP to Remove
Routing Mode
SPs assigned to destination 1:
1, 2
Destination — sets the destination that you want to define. Choices are 1 - 4
(standard destinations), and Aux 1 - 4 . This field is independent of the
destination(s) currently selected on the Destination Bus .
Note The destination that you select does equate to the same
destination button on the Controller.
Type — displays (or sets) the selected destination type.
~
For standard destinations:
• Displays [Single Screen SP] if one ScreenPRO-II has been
added to the destination's configuration.
• Displays [Widescreen SP] if two, three or four ScreenPRO-IIs
have been added to the destination's configuration.
~
For Aux destinations, enables you to select between Aux , ImagePRO
Aux or PrePRO-II Aux destinations.
Note When Aux 1 , 2 , 3 , or 4 is selected, the { AUX SETUP } button
appears, which enables you to set Aux destination
parameters. Refer to the "
on page 120 for details.
4. Menu Orientation
}
to display the Destination Setup Menu .
1
[ Widescreen SP ]
[ N/A ]
1
External
REMOVE ADD
Aux Destination Setup
System Menu
N
A
V
A
D
J
" section
117