Barco ScreenPRO-II User Manual page 209

táÇÉëÅêÉÉå=mÜ~ëÉ=~åÇ=`çäçê=_~ä~åÅÉ=pÉíìé
This section provides instructions for phase and color balance setup for wide widescreen
destinations utilizing BlendPRO-II. Please note the following important points:
•
•
•
•
•
mÜ~ëÉ=^ÇàìëíãÉåíë
Use the following steps to set up phase for widescreen destinations — for RGB and
YUV sources only.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. On the PIP Adjustment Menu , use H Size and V Size to size the PIP such that
11. Press AUTO TRANS to transition the PIP to program. This will ensure that you
12. Using the H Position function, move the PIP into the screen 1 region.
13. Press HOME > INPUT > { SIZING } to display the Sizing Menu for the source.
14. On the Destination line, select the "screen 1" destination.
15. Adjust Clock Phase for the cleanest and brightest image.
16. If required, adjust H Position so that all of the image's pixels are visible.
17. Press PIP to display the PIP Adjustment Menu .
ScreenPRO-II Controller • User's Guide
For the optimum setup, it is highly recommended that you can output a test
pattern from each source — however, you can make adjustments using a live
image if necessary. For example, if the source is a PC, the best results can be
achieved when a full screen test pattern can be generated on the desktop.
A test pattern application is available on the website (
Click Downloads , select BlendPRO from the drop-down list, then download the
Alignment Patterns application.
The following "phase adjustment" steps apply to RGB and YUV analog sources.
The following "color balance" steps apply to all types of analog sources — RGB ,
YUV , Composite and S-Video .
The following adjustment steps are not required for digital sources.
Note These adjustments are primarily visual, rather than precisely
numerical. Here, for each destination, you are visually
matching sources across your system's scalers.
Ensure that you have performed the "standard" setups for your sources. If not,
refer to the " Standard Input Setup
From the Home Menu , press SYSTEM to display the System Menu .
Turn the Modify Layers on Program function to On .
On the Destination Bus , select your widescreen destination.
On the ScreenPRO-II Controller console, select LAYER A .
On the Source Selection Bus , select the first source that you want to set up.
Press PIP to display the PIP Adjustment Menu .
Ensure that the image's border and shadow are turned off. Use the Border Menu
and Shadow Menu as required.
( Recommended ) Output a Burst test pattern from the selected source.
that it matches the input's resolution. In this way, there will be no scaling .
can make your adjustments with data doubling and edge feathering visible.
5. System Setup
http://video.folsom.com
" section on page 206 for details.
Input Setup
).
209