Sync Setup - Barco ScreenPRO-II User Manual

5. System Setup

Sync Setup

póåÅ=pÉíìé
ScreenPRO-II Controller system setup: Step 12
12
In this procedure, you will set up sync parameters for the monitors and projectors
connected to the system — for the destination selected on the Output Menu .
Use the following steps to set up sync parameters:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Repeat from step 2 to set sync parameters for additional destinations.
11. Press
12. Press
200
Prerequisites — Ensure that you are familiar with the Settings Menu . In
Chapter 4, refer to the "
Note It is recommended that you leave the sync parameters at their
default (factory reset) values. However, should you need to
adjust individual settings for a particular monitor and projector
configuration, use the following procedure.
From the Home Menu , press OUTPUT to display the Output Menu .
On the Destination Bus , select the destination that you want to configure.
{ }
Press SETTINGS to display the Settings Menu .
On the Output Monitor line, select the device(s) that are affected by the sync
settings — All , Preview , SPII Program or BPII Program .
On the Sync Out line, set the desired sync value — +H+V , -H-V , +H-V , -H+V or
CSync .
On the SOG line, select a specific "sync on green" signal — Off , Standard or Tri-
Level (for certain HD devices).
On the Gamma line, set the output gamma for the selected destination.
Important It is recommended that you leave Gamma at the unity setting
( 1.0 ). Change the value only if you need to compensate for a
gamma problem in your projector or monitor.
On the Raster Box Size line, set the size of the raster box that appears around
PIPs and Keys.
Note As required, you can change the Raster Box value during
operations without affecting sync settings.
{ }
Press BACK to return to the Output Menu .
{ }
HOME to return to the Home Menu .
{ }
SAVE to save the new system configuration in memory.
Settings Menu " section on page 104.
ScreenPRO-II Controller • User's Guide