Id Setup And Remote Enable; System Power Up; Return To Factory Default; Touch Screen Calibration - Barco ScreenPRO-II User Manual

póëíÉã=pÉíìé=pÉèìÉåÅÉ
This section provides a top level view of the entire ScreenPRO-II Controller setup
procedure, plus links to each individual procedure.
Preliminary steps:
1.
2.
3.
Next, set up all menus under the MISC heading:
4.
5.
6.
Next, set up all menus under the System heading:
7.
8.
9.
10. "
Next, set up all menus under the Output heading:
11. "
12. "
13. "
14. "
Set up all background inputs and primary sources:
15. "
16. "
17. "
18. "
To complete your setup:
19. "
20. "
All of the above procedures are covered in the following sections.
ScreenPRO-II Controller • User's Guide
Important For the optimum ScreenPRO-II Controller system setup, it is
recommended that you follow all procedures in the order
outlined below.
"

ID Setup and Remote Enable

"

System Power Up

," page 187.
"

Return to Factory Default

"

Touch Screen Calibration

" Programming EDID ," page 190.
" Restore from Flash Memory Card
" Standard Destination Setup
" ," page 193.
Router Setup
" AUX Destination Setup ," page 195.
Input Patching ," page 198.
Output Format Setup ," page 199.
Sync Setup ," page 200.
Genlock Setup ," page 201.
Projector Setup ," page 202.
," page 205.
Background Setup
Input Setup ," page 206.
DSK Setup Procedure ," page 211.
LOGO Setup Procedure
Saving the Setup ," page 213.
Backup to Flash Memory Card
," page 186.
," page 189.
," page 189.
," page 191.
," page 192.
," page 212.
," page 213.
5. System Setup
System Setup Sequence
185