Effects Menu - Barco ScreenPRO-II User Manual

4. Menu Orientation

Effects Menu

bÑÑÉÅíë=jÉåì
The figure below illustrates a sample Effects Menu :
H
O
M
E
Figure 4-48. Effects Menu (sample)
To access the menu:
•
The Effects Menu allows you to modify and manage effects on a destination-by-
destination basis, including the ability to define key frames, paths and effect properties.
The following functions are provided:
•
•
•
•
•
In Chapter 6, refer to the "
146
EFFECTS MENU
Destination
Key Frame Effect
Transition Rate
Transition Wipe
Transition Edge Width
! Wide Screen destinations
only support Mix Transition
! Keyframe Effects are ignored
by ScreenPROII destinations
Press EFFECTS on the Home Menu .
Destination — displays the currently selected destination.
Key Frame Effect — enables you to select the type of motion for a "move."
Note Only the Linear motion type is supported. All other key frame
effects are ignored by ScreenPRO-II destinations.
Transition Rate — sets the auto-transition rate that is used when the Auto Trans
button is pressed. The transition value is in 0.1 second increments.
Transition Wipe — sets the transition type when the WIPE button is selected.
Choose between Wipe Right , Wipe Left , Wipe Down , Wipe Up , Curtain Open ,
Curtain Close , Box In and Box Out .
Note Wide screen destinations only support Mix transitions. Key
frame effects are ignored by ScreenPRO-II destinations.
Transition Edge Width — When WIPE is selected, this field enables you to set
the transition's edge type. The range (in pixels) is from 0 to 256 .
Working with Transitions
1
N
A
V
LINEAR
1.0
Wipe Right
16
A
D
J
" section on page 241 for instructions.
ScreenPRO-II Controller • User's Guide