Barco ScreenPRO-II User Manual page 78
Hide thumbs
Also See for ScreenPRO-II:
- Brochure (4 pages) ,
- Brochure & specs (6 pages) ,
- User manual (206 pages)
Table of Contents
Advertisement
3. Hardware Installation
BlendPRO-II Widescreen Lock Connections
78
b.
Connect the first ScreenPRO-II's GENLOCK LOOP connector to the
GENLOCK IN connector on the ScreenPRO-II unit with the next highest
numbered ID .
c.
(If your system includes three ScreenPRO-IIs) — Connect the second
ScreenPRO-II's GENLOCK LOOP connector to the GENLOCK IN
connector on the ScreenPRO-II with the next highest numbered ID .
(If your system includes four ScreenPRO-IIs) — Connect the third
d.
ScreenPRO-II's GENLOCK LOOP connector to the GENLOCK IN
connector on the ScreenPRO-II unit with the highest numbered ID .
e.
Set the Termination Switch for all ScreenPRO-IIs in your system:
•
For all ScreenPRO-IIs except the last one in the chain, ensure
that the ScreenPRO-II is un-terminated ( HI-Z ). Refer to the
"
ScreenPRO-II Genlock Termination
details.
•
On the last unit in the chain (only), ensure that the
ScreenPRO-II is terminated ( 75-OHM ).
" section on page 76 for
ScreenPRO-II Controller • User's Guide
Advertisement
Table of Contents
