Table of Contents
Advertisement
4.8.8 Genlock utility
The genlock utility enables alternatively to the window manager access to the genlock functionality, please refer
also to section
4.5 Window
means of the window manager.
Entering xgenlock in the command line starts the utility:
xgenlock
xgenlock>>
In the following the options can be entered, e.g. on to switch on genlock:
xgenlock>>on
The following table lists the options of xgenlock:
option
help | ?
quit
off
on
external
internal
bvsync <n>
qvsync <n><m>
firstsync
info
state
monitoring <l>
version
rdef
wdef
ras <file>
was <file>
When using genlock make sure, that the cabling for genlock has been established as
explained in section
If an external signal is connected only external may be selected. If selecting internal or a
video signal it will be disturbed by the external signal. Therefore the external signal should
be unplugged before switching to an other type of genlock!
Barco – Argus X Terminal – DOC-3265-2 – user's manual – Revision 04 – May-2004
manager. But it offers also access to advanced functionality that is not operable by
value / meaning
lists all options of xgenlock
quits the utility
switches genlock off
switches genlock on
selects an external source as genlock signal
selects the first UGX or
GX or AGX G
n=0,1,2, ...
selects the B
V
C
IG
IDEO
ARD
This is only applicable using the following components:
A
O
B
AGS-3013-11 or higher
RGUS
MNI
US
O
S
AGX-3002-0 or higher
MNI
CALER
B
V
C
FRG-2684-14 or higher
IG
IDEO
ARD
n=0,1,2, ... ; m=0,1,2,3
selects the Q
A
V
UAD
NALOG
lock signal
selects the first video input card as genlock signal
returns a list with information, if genlock is activated and which card is used for the
genlock signal
returns a list with the state of the UGX or AGX G
l=1,2,3, ...
repeats the option state <l> times
shows the version of the boot loader
(genlock can be used from boot loader version 204 on)
reads and applies the default configuration file
writes the current genlock settings into the default configuration file; these settings
are applied automatically after each restart.
reads and applies the configuration file, that is specified with <file>
writes the current genlock settings into a configurations file with the name <file>
3.2.14 CPU board
U
board.
C
as genlock signal
RAPHIC
ARD
with the number <n> as genlock signal
with the number <n> and channel <m> as gen-
C
IDEO
ARD
RAPHIC
________________________________________________________________________
4. Operating
C
(r (refresh rate, ..)
ARDS
options of the xgenlock utility
Table 4-43
4-60
Advertisement
Table of Contents
