Projector Setup; Single Screen Projector Setup; Wide Screen Projector Setup - Barco ScreenPRO-II User Manual

5. System Setup

Projector Setup

mêçàÉÅíçê=pÉíìé
ScreenPRO-II Controller system setup: Step 14
14
In this section, you will set up your projectors for both single screen and widescreen
destinations. The following procedures are provided:
•
•
páåÖäÉ=pÅêÉÉå=mêçàÉÅíçê=pÉíìé
Use the following steps to set up a projector for a single screen destination:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. At the projector itself, adjust color balance, brightness and contrast.
11. Once the projector is properly set, turn Off both the Raster Box and the Mode .
12. Press
202
Prerequisites — Ensure that you are familiar with the following menus and
applications:
~
Test Pattern Menu . In Chapter 4, refer to the "
section on page 105.
~
Wide Screen Menu . In Chapter 4, refer to the "
Menu " section on page 106.
~
Configurator Application . You can use the Configurator application to
assist with wide screen setup. The software is available via download
from the website, or contact Barco Technical Support . In Appendix B,
refer to the " Contact Information

Single Screen Projector Setup

Wide Screen Projector Setup

From the Home Menu , press OUTPUT to display the Output Menu .
On the Destination Bus , select the destination whose projector you want to
configure.
{ }
Press TEST PATTERN to display the Test Pattern Menu .
On the Output Monitor line, select the output(s) on which you want a test pattern
to appear — All , Preview , SPII Program or BPII Program .
On the Mode line, select On .
On the Type line, select the Burst test pattern.
On the Raster Box line, select On .
At the projector itself, perform the following adjustments to ensure that the output
data from the selected device is properly displayed:
~
Adjust the image for a minimum amount of noise.
~
Adjust the pixel clock for proper image position, such that the entire
Raster Box is visible.
On the Type line, select one of the many Gray Scale test patterns, as desired.
Important Refer to your projector's technical manual for information on
all projector setup and adjustment procedures.
{ }
BACK to return to the Output Menu .
Test Pattern Menu
Wide Screen Settings
" section on page 268 for information.
ScreenPRO-II Controller • User's Guide
"