Barco ScreenPRO-II User Manual page 194
Hide thumbs
Also See for ScreenPRO-II:
- Brochure (4 pages) ,
- Brochure & specs (6 pages) ,
- User manual (206 pages)
Table of Contents
Advertisement
5. System Setup
Router Setup
15. Press
16. Press
Table 5-1. Default Output Patch Table
17. To "custom" patch router outputs, use the following steps:
18. To designate a router output as an "Aux" output:
19. Press
194
{
}
BACK
to return to the Router Specification Menu .
{
}
OUTPUT PATCH
router. On the top line, note the router name and confirm that this is the router that
you wish to patch.
The table below illustrates the default output patch table (as configured after a
factory reset). The table is valid for both analog and digital routers.
Router Output
ScreenPRO-II ID
1
1
2
1
3
2
4
2
5
3
6
3
7
4
8
4
If you have a Folsom MatrixPRO Router and you have connected the router
outputs per the table above, no setup is necessary on the Output Patch Menu —
unless you specifically want to patch the outputs in a different manner. This
"default" configuration is ideal for most single and widescreen applications.
a.
On the Router Output line, select the output that you want to patch.
b.
If you are uncertain about the current patch, or if you want to remove the
current (existing) patch and start clean, press { DELETE PATCH }.
c.
On the Device ID line, select the ScreenPRO-II ID to which you want to
patch the selected router output.
d.
On the SP Input line, select the specific ScreenPRO-II input to which
you want to patch the selected router output.
e.
Press { ADD PATCH } to confirm your changes. The new "mapping"
appears on the menu.
f.
Repeat step 17 to patch additional outputs.
a.
On the Router Output line, select the specific router output that you
want to designate as an Aux output.
b.
If you are uncertain about the current patch, or if you want to remove the
current (existing) patch and start clean, press { DELETE PATCH }.
c.
On the Device ID line, select None .
d.
Press { ADD PATCH } to confirm the change.
e.
Repeat step 18 to designate additional Aux outputs.
{
}
BACK
to return to the Router Specification Menu .
to display the Output Patch Menu for the selected
ScreenPRO-II Input
(Analog or SDI)
1
2
1
2
1
2
1
2
ScreenPRO-II Controller • User's Guide
Advertisement
Table of Contents
