Working With Transitions; Cut; Mix; Wipe - Barco ScreenPRO-II User Manual

6. Operations
tçêâáåÖ=ïáíÜ=qê~åëáíáçåë
This section provides instructions for perform a variety of transitions. The following topics
are discussed:
•
•
•
•
•
`ìí
Cuts can be performed on both single screen and widescreen destinations.
Use the following steps to perform a Cut :
1.
2.

CUT

jáñ
A Mix (or Dissolve) can be performed on both single screen and widescreen destinations.
Use the following steps to perform a Mix :
1.
2.

MIX

3.
4.
táéÉ
All types of wipes can be performed on single screen destinations. On widescreen
destinations, you can perform a Wipe Up or Wipe Down .
Use the following steps to perform a Wipe :
1.
2.

WIPE

ScreenPRO-II Controller • User's Guide
Cut
Mix
Wipe

Manual Transitions

Transition Notes

Set up the desired "look" in Preview.
In the Transition Section , press CUT to instantly cut the setup to Program.
Set up the desired "look" in Preview.
Preset the desired transition rate:
a. Press { HOME } > { EFFECTS } to display the Effects Menu .
Adjust the Transition Rate field for the desired rate, in 0.1 second
b.
increments.
In the Transition Section , press MIX .
Press AUTO TRANS to dissolve the setup to Program.
Set up the desired "look" in Preview.
Preset the desired transition rate, wipe effect and wipe edge:
a. Press { HOME } > { EFFECTS } to display the Effects Menu .
b. Adjust the Transition Rate field for the desired rate, in 0.1 second
increments.
c. Adjust the Transition Wipe field for the desired wipe pattern.

Working with Transitions

241