Edid Dvi Input Format Menu - Barco ScreenPRO-II User Manual

In Chapter 6, refer to the "
instructions on using the Controller Panel Lockou t mode.
bafa=asf=fåéìí=cçêã~í=jÉåì
From the Miscellaneous Menu , press
Menu :
B
A
C
K
Figure 4-40. EDID DVI Input Format Menu (sample)
The EDID DVI Input Format Menu enables you to update the system's preferred EDID
resolution for each ScreenPRO-II's two DVI inputs ( Background and DSK ) — for the
selected destination bus.
Extended Display Identification Data (EDID) is a VESA standard data format that contains
information about a display device and its resolution, both preferred and allowed. The
system's EDID file is stored in non-volatile memory. This file is read by an external
computer's DVI graphic card when the computer's DVI output is connected to ScreenPRO-
II via the DVI-I connector during boot-up. The ScreenPRO-II must be powered on first for
the EDID information to be read.
The following functions are provided:
•
•
•
•
ScreenPRO-II Controller • User's Guide
To enter a new lockout code, use the eight numbered buttons on the Source
Selection Bus , and then confirm the new code.
Locking and Unlocking the Controller
EDID DVI INPUT FORMAT
Destination
FORMAT:
Current EDID format
To change EDID for DVI inputs,
select the desired format and
select Program EDID.
Note This menu is designed for advanced users only. Do not
program the EDID unless it is necessary.
Destination — sets the destination bus on which you want to program EDID — all
or individual ScreenPRO-II units.
Format — selects the preferred DVI video format with which you want to program
the selected ScreenPRO-II(s) EDID non-volatile memory
Current — displays the current EDID video format that resides in memory.
Press { PROGRAM EDID } to program EDID with the new selected format. A
warning message will be shown.
4. Menu Orientation
{ }
EDID to display the EDID DVI Input Format
ALL
1280 x 1024 @ 60
1280 x 1024 @ 60
PROGRAM
EDID
Miscellaneous Menu
" section on page 252 for
N
A
V
A
D
J
137