Barco ScreenPRO-II User Manual page 131

i~åíêçåáñ=pÉíìé=jÉåì
On the Router Specification Menu , when Communication Type is set to LANTRONIX ,
{
press COMM SETUP
B
A
C
K
Figure 4-33. Lantronix Setup Menu (sample)
The Lantronix Setup Menu enables you to set parameters for multiple Lantronix Ethernet-
to-Serial device servers. The ScreenPRO-II Controller supports Lantronix models UDS100
and UDS200 . The menu will appear blank until the Lantronix device is "discovered."
•
•
•
•
•
•
•
•
•
ScreenPRO-II Controller • User's Guide
}
to display the Lantronix Setup Menu :
LANTRONIX SETUP
Number
Channel
Baud rate
Data bits
Stop bit
Parity
IP: N/A
MAC Addr: [ N/A ]
DISCOVER
LTRX
Important Prior to pressing
recommended that you set up a static IP address on the
Lantronix device itself. The recommended range is
192.168.0.200 - 192.168.0.239 — such as not to conflict with
other devices in the ScreenPRO-II Controller system. Refer
to the Lantronix UDS100 or UDS200 User's Guide for
instructions.
Number — selects the number of the Lantronix device that you wish to set up.
{ }
Press DISCOVER LTRX
Channel — sets the specific Lantronix channel ( 1 or 2 ) that you wish to set up.
Each Lantronix can control two serial routers.
Baud Rate — sets the selected channel's baud rate.
Data Bits — sets the selected channel's data bits.
Stop Bit — sets the selected channel's stop bit.
Parity — sets the selected channel's parity.
IP — displays the IP address of the Lantronix. This parameter must be set at the
device itself.
MAC Addr — displays the hard-coded MAC address of the Lantronix.
< EMPTY >
[ N/A ]
[ N/A ]
[ N/A ]
[ N/A ]
[ N/A ]
{
DISCOVER LTRX
to set up communications with the Lantronix device.
4. Menu Orientation
System Menu
N
A
V
A
D
J
}
, it is highly
131