Barco ScreenPRO-II User Manual page 254

6. Operations
Using Backup and Restore
7.
8.
póëíÉã=oÉëíçêÉ
Please note the following important points regarding the "restore" function:
•
•
Use the following steps to restore from the flash memory card: Please note the
following important points:
1.
2.
3.
4.
5.
6.
7.
8.
At the conclusion of this procedure, your system is completely set up — exactly the way
that you left it when you performed a complete system "backup."
254
Press { CHECK CARD } to check for the presence of a Flash Memory Card.
Press { BACKUP } to perform a backup operation to the Flash Memory Card using
the selected device(s) and options.
When restoring, you must have the same version of software installed in the
Controller as was used to perform the backup.
Conversion between versions can only be done with the Barco Backup and
Restore utility.
Note The Barco Backup and Restore utility can be found in the
ScreenPRO-II Controller software bundle — available via
download from the website.
Ensure that your flash memory card is properly inserted in the Controller's
MEMORY CARD slot on the rear panel.
On the Home Menu , press MISC to access the Miscellaneous Menu .
{
Press BACKUP RESTORE
Press { CHECK CARD } to ensure that the Controller recognizes the card.
On the Device line, select Ctrlr+SP to perform a complete restore, or select a
subset as desired.
On the Controller Options line, select All , or select a subset as desired.
On the SP to Restore line, select All , or select a subset as desired.
Press { RESTORE } to restore the selected system configuration.
}
to display the Backup/Restore Menu .
ScreenPRO-II Controller • User's Guide