Standard Destination Setup - Barco ScreenPRO-II User Manual

5. System Setup

Standard Destination Setup

pí~åÇ~êÇ=aÉëíáå~íáçå=pÉíìé
ScreenPRO-II Controller system setup: Step 7
In this procedure, you will set up the system's "standard" destinations (single screen and
7
widescreen) on the Controller's Destination Bus .
Use the following steps to set up a single screen or a widescreen destination:
1.
2.
3.
4.
5.
6.
7.
8.
9.
This completes the procedure for defining single and widescreen destinations. The
selected buttons on the Destination Bus are now active.
192
Prerequisites — Ensure that you are familiar with the Destination Setup
Menu . In Chapter 4, refer to the "
page 117.
Note Up to 4 "standard" destinations can be assigned (single
screen and widescreen), but only 1 widescreen destination is
allowed.
From the Home Menu , press SYSTEM to access the System Menu .
{ }
Press DEST SETUP to display the Destination Setup Menu .
Scroll to the Destination line and select the destination that you want to define —
either 1 , 2 , 3 or 4 .
Scroll to the SP to Add line and select the ID of an available ScreenPRO-II. If a
ScreenPRO-II is already assigned to a destination, it will not appear in the list.
Note When there are no more ScreenPRO-IIs available to assign,
the right-hand column displays N/A .
{ }
Press ADD to add the highlighted ScreenPRO-II to the destination. Once
added, the ID will appear in the bottom portion of the menu. Please note:
~
For a Single Screen configuration, add only one ScreenPRO-II. Repeat
from step 3 to define all remaining single screen destinations.
~
For a Wide Screen configuration, add as many ScreenPRO-IIs as
required — up to the maximum of 4.
If required, scroll to the SP to Remove line and select the ID of a ScreenPRO-II
that you want to remove from the current configuration. Press
clear the ScreenPRO-II from the destination.
{ }
Press BACK to return to the System Menu .
Important If the ScreenPRO-II Genlock Termination Menu appears
after you press
problem. In Chapter 4, refer to the "
Termination Menu
{ }
Press HOME to return to the Home Menu .
{ }
Press SAVE to save the new system configuration in memory.
Destination Setup Menu
{
BACK }, there is a termination switch
ScreenPRO-II Genlock
" section on page 119 for details.
ScreenPRO-II Controller • User's Guide
" section on
{ }
REMOVE to